Panel 20® is a composite panel for exterior use made by laminating an aluminum skin to a substrate of thermoset phenolic resin. A second aluminum skin is added as a backer and provides thermal stability and panel balance. This system is designed for use as exterior cladding on walls, canopies, fascias, and accent bands. However, Panel 20® is also ideal for other applications where a high end look is desired.

Similar to Envelope 2000®, Panel 20® is impact resistant, water resistant, and provides ultimate smoothness in a wide variety of finishes. However, Panel 20® is installed using a variety of moldings, saving on the fabrication and installation costs.  

Attached to the substrate with concealed screws, Panel 20® offers two piece aluminum moldings to complete the panel joints.  These moldings (available in batten and reveal profiles) consist of plastic receiver attached prior to the panel, then finished with a prepainted cover to match or complement the panel. 

In addition to perimeter fastening, Panel 20® should be adhered to the substrate in the field of the panel. 

Installation is non-progressive when using these moldings allowing panels to be removed and replaced should damage occur.

 Installation Videos:

Two Piece Molding System

• 

  C20-401

• C20-401
• C20-402
• C20-403
• C20-404
• C20-405
• C20-406
• C20-407